Classified Ads: Swap Parts Here!

buy, sell, or trade - cars, parts, tools, etc. (Please keep ads out of the other forums!)

Go to Thread: Previous•Next
Go to: Forum List•Message List•New Topic•Log In


Wotland
Wotland Wotland

(105 posts)

Registered:
01/07/2008 08:14AM

Main British Car:
Wanted rods for 3.4" stroker kit buick 215
Posted by: Wotland
Date: August 18, 2009 04:38AM

Hello, I am looking for either 5.7" narrowed chevy rods or modified buick rods to accept for Ford 0.912" wrist pin.

Thank.


roverman
Art Gertz
Winchester, CA.
(3188 posts)

Registered:
04/24/2009 11:02AM

Main British Car:
74' Jensen Healy, 79 Huff. GT 1, 74 MGB Lotus 907,2L

Re: Wanted rods for 3.4" stroker kit buick 215
Posted by: roverman
Date: September 12, 2009 07:39PM

Get your Chevy rods yet? Don't recommend the Buick"cast" rods. Anyone with a engine lathe that will, "swing" the chev. rod can carefully narrow them. Use a 6 jaw chuck or an internal expanding mandrel. Watch the "off-set"! I think it's around .030" vs. .070", side/side to get top of rod on-center. D&D ? Good Luck, roverman.


Go to: Forum List•Message List•New User Registration•Log In
Sorry, only registered users may post in this forum.