MG Sports Cars

engine swaps and other performance upgrades, plus "factory" and Costello V8s

Go to Thread: Previous•Next
Go to: Forum List•Message List•New Topic•Log In


rkas3882
randy kassed

(84 posts)

Registered:
05/30/2010 09:14AM

Main British Car:
1973 mgb gt rover 3.5

efi harness question rover v8
Posted by: rkas3882
Date: March 06, 2012 09:18PM

Hey guys, for those of you running rover efi how did you run the harness into the passenger compartment? Just looking for a better option than running it through the square blanking plug. Just want it to look neat, pics would be appreciated.
Randy


BlownMGB-V8
Jim Blackwood
9406 Gunpowder Rd., Florence, KY 41042
(6470 posts)

Registered:
10/23/2007 12:59PM

Main British Car:
1971 MGB Blown,Injected,Intercooled Buick 340/AA80E/JagIRS

authors avatar
Re: efi harness question rover v8
Posted by: BlownMGB-V8
Date: March 07, 2012 08:14AM

For my MS-II controller I ran the wires through the bulkhead grommet that the wiring harness goes through. Tight fit but it works.

Jim


Jahdave
David Cousins
Campbell, California
(13 posts)

Registered:
09/13/2008 02:15AM

Main British Car:
1977 MGB Rover 3.5 V8

Re: efi harness question rover v8
Posted by: Jahdave
Date: March 07, 2012 05:57PM

I also ran it through the big rubber grommet on the passenger side. I cut the grommet to make a neat hole.
Get Your BritishV8 T-shirt by clicking here


Go to: Forum List•Message List•New User Registration•Log In
Sorry, only registered users may post in this forum.