Engine and Transmission Tech

tips, technology, tools and techniques related to vehicle driveline components

Go to Thread: PreviousNext
Go to: Forum ListMessage ListNew TopicLog In

Richard Gibson

(1 posts)

01/15/2008 01:50AM

Main British Car:

Rover bellhousing bolt pattern needed
Posted by: tellicorick
Date: January 15, 2008 02:03AM

Hello from Southeastern US. I've been searching, posting and looking for the bellhousing bolt pattern for the back side of the Land Rover 4.0 liter engine; which I'm told is identical to the Buick, since LR bought this engine from GM and has been using them since the late 60s. What I need is some type of drawing file (either pdf or dxf) showing the locating pins and bolt hole dimensions referenced off the crankshaft centerline and the diameter of the holes.

I'm doing an engine swap; Gen IV series small block Chevrolet into my Land Rover Discovery and need these dimensions so I can build the adapter to mate the engine with the ZF auto transmission. If anyone knows where I can find this file or has access to this file, please e-mail me at: rgizbone@knology.net

Richard Gibson
Huntsville, Alabama

Edited 1 time(s). Last edit at 01/15/2008 02:06AM by tellicorick.

Sorry, only registered users may post in this forum.