Bodywork, Paint, Interior, Trim, & Wiring

discussions about bodywork, paint, interiors, trim, audio, electrical components, wiring, etc.

Go to Thread: PreviousNext
Go to: Forum ListMessage ListNew TopicLog In


Kernel-K
Bill Kowalewski

(6 posts)

Registered:
08/17/2014 11:04AM

Main British Car:


Early / late door pull swap
Posted by: Kernel-K
Date: October 09, 2014 03:16PM

Do the early chrome interior door pulls and later (i.e. my 1977 RB) padded door pulls share the same mounting dimensions and location? A simple unscrew/screw-in swap ? Thanks. Only a few hundred questions to go...



Edited 1 time(s). Last edit at 10/09/2014 03:25PM by Kernel-K.


rkas3882
randy kassed

(84 posts)

Registered:
05/30/2010 09:14AM

Main British Car:
1973 mgb gt rover 3.5

Re: Early / late door pull swap
Posted by: rkas3882
Date: October 20, 2014 11:20PM

well yes and no. The holes are in the door frames for the early pull handles on the inside but the threaded section is not there and the padded pulls are not using the same holes as the early chrome door pulls use.


MGBV8
Carl Floyd
Kingsport, TN
(3922 posts)

Registered:
10/23/2007 11:32PM

Main British Car:
1979 MGB, Buick 215

authors avatar
Re: Early / late door pull swap
Posted by: MGBV8
Date: November 14, 2014 01:07PM

Takes a bit of work, but is do-able. There is a post that shows HIWD buried over on the MG Experience forum.


Sorry, only registered users may post in this forum.